| Step | | Procedure & Parts & Tools |
| 1 |
|
REMOVE THE 2 SCREWS HOLDING THE HANDLE COVER TO MACHINE.
| Screwdriver-flat tip |
|
|
| 2 |
|
LIFT HANDLE COVER OFF MACHINE.
|
| 3 |
|
LOCATE THE HALL SENSOR SWITCH ASSEMBLY. REMOVE THE 2 SCREWS HOLDING HALL SENSOR ASSEMBLY TO THE MACHINE.
| Screwdriver-phillips |
|
|
| 4 |
|
PULL THE BLACK COVER APART TO LOCATE HALL SENSOR.
|
| 5 |
|
REMOVE THE 2 SCREWS FROM THE BOTTOM OF THE CONTROL PANEL.
| Torx T20 |
|
|
| 6 |
|
LIFT UP ON THE CONTROL PANEL TO EXPOSE HALL SENSOR CABLE.
|
| 7 |
|
LOCATE THE BLUE RIBBON CABLE AND PLUGS.
|
| 8 |
|
DISCONNECT THE HALL SENSOR PLUGS FROM THE CONTROL PANEL.
|
| 9 |
|
REMOVE THE CENTER BOLT IN HANDLE.
| Wrench-Allen metric 4.0mm |
|
|
| 10 |
|
LIFT UP ON THE HANDLE ASSEMBLY TO REMOVE IT FROM THE MACHINE.
|
| 11 |
|
PULL THE BLUE RIBBON CABLE FROM THE SPOT WHERE THE HANDLE ASSEMBLY WAS UNTIL IT IS FREE FROM MACHINE. REVERSE STEPS 1 THRU 11 TO REPLACE THE HALL SENSOR ASSEMBLY,
|